Connect, replace & adjust the Galaxy Watch3's band length

Last Update date : Aug 04. 2022

Putting on the Galaxy Watch3

Open the buckle and place your Galaxy Watch3 around your wrist. Fit the band to your wrist, insert the pin into an adjustment hole, and then secure the buckle to close it. If the band is too tight on your wrist, use the hole one further out.

For the metal band, add or remove the metal band links to adjust its length to fit the band to your wrist before wearing and securing the buckle to close it.

 

Please note:
• Do not bend the band excessively. Doing so may damage the Galaxy Watch

• When you wear the Galaxy Watch3 for a long time or do a high-intensity exercise while wearing it, skin irritation may occur due to friction and pressure. If you wearing your Galaxy Watch3 for a long time, remove the Galaxy Watch3 from your wrist and do not wear your Galaxy Watch3 for several hours.

• Skin irritation may occur due to an allergy, environment factors, other factors, or when your skin is exposed to soap or sweat for long periods. In this case, stop using your Galaxy Watch3 and wait 2 or 3 days for the symptoms to ease. If the symptoms persist or worsen, immediately call your doctor.

• Make sure your skin is dry before wearing your Galaxy Watch3. If you wear a wet Galaxy Watch3 for a long time, your skin may be affected.

• If you use your Galaxy Watch3 in the water, remove foreign materials from your skin and Galaxy Watch3 and dry them thoroughly to prevent the skin irritation.

• Do not use any accessories except the Galaxy Watch3 in the water.

 

Connecting or replacing the band and adjusting its length

Connect the band before using your Galaxy Watch3. You can detach the band from the Galaxy Watch3 and replace it with a new one. You can also adjust the metal band’s length by adding or removing links from it.

 

Be careful to not hurt your fingernail when sliding the spring bar while connecting or replacing bands.

 
1 Insert one end of the band’s spring bar into the Galaxy Watch3’s lug.
2 Slide the spring bar inwards and connect the band.
1 Slide the band’s spring bar inwards.
2 Pull the band away from the Galaxy Watch3’s body while sliding the band’s spring bar inwards.
3 Connect the new band to your Galaxy Watch3.

Connect the metal band with the groove to the top of your Galaxy Watch3 to avoid covering its atmospheric pressure sensor.

 
1 Slide both of the metal band spring bars inwards.
2 Slide the metal band into your Galaxy Watch3 as shown in the image below, and place both of the metal band spring bars so that they connect to the Galaxy Watch3’s body. Slide both metal band spring bars outwards again to check if they connected completely.
1 Pull the metal band away from the Galaxy Watch3’s body while sliding both metal band spring bars inwards.
2 Connect the new band to your Galaxy Watch3.

You can adjust the metal band length to be as many links as you want to use. The tweezer used for grabbing the pin when adjusting the metal band length is supplied in the package.

 
1 Press the centre button on the link to be removed to make the pin stick out from the side.
2 Pull out both the upper and lower pins of the link to be removed with the supplied tweezer. The link will be removed from the main metal band.
3 Reconnect both sides of the metal band which are disconnected and press the pin to assemble until it clicks. When assembling the pin, be careful for your safety.

You can download the user manual from our Manuals & Downloads page. For all other queries or further technical assistance, please call Samsung Customer Care on 0800 726 786 or Live Chat with our Technical Team online, services are open 24 hours, 7 days.

Thank you for your feedback!