How to apply a protection film to the Galaxy Z Fold5

Step 1. Unfold your Galaxy Z Fold5 and place the main display face down on a soft, flat, non-slip surface.

Step 2. Pick up the applicator and remove all of the adhesive protection stickers.

Step 3. Place the applicator beside the bottom right corner of the phone and align them > Touch the top tip of the applicator to the side of the phone.

Step 4. Rotate the applicator until it is flush and secure against the device.

Step 5. Thoroughly wipe any foreign substances off the screen with the microfiber cleaner.

Step 6. Use the dust remover to dab any remaining dust from the phone screen.

Step 1. Pick up the cover protection film and remove the sticker label.

Step 2. Flip the protection film over so that the adhesive side is facing down.

Step 3. Align the holes in the protection film with the camera lens and the applicator, but do not allow it to touch the cover surface.

Step 4. Press the protection film’s adhesive to ensure a strong bond.

Step 5. Lift the top portion of the protection film and bend it to the halfway point. The blue protective sheet should begin to separate from the clear protection film.

_{* To ensure you do not peel the protective film farther than you need to, place the provided squeegee at the halfway point where the blue protective sheet begins to separate from the clear protection film.}

Step 6. Push the squeegee forward to apply the clear protection film while removing the top half of the blue protective sheet.


_{* Maintain a steady, even pressure to avoid creating any air bubbles.}

Step 7. Turn the phone 180 degrees.

Step 8. Detach the blue film from the applicator, and then remove the applicator from the phone.

Step 9. Repeat steps 4 and 5 to apply the second half of the cover protection film.

Step 10. Then, position the squeegee in the center of the screen at the top of the device. Apply pressure pushing outwards from the center to the left and right edges, moving from the top to the bottom.

Step 11. Fold the phone closed. Then, remove the protection film’s outer transparent film by grabbing the label and gently pulling it down.

Step 12. Rub the edges with the microfiber cleaner to eliminate any remaining gaps.